Where to find high-flow air filters and installation matters

　　When the vehicle's driving distance reaches the maintenance interval specified for the high flow air filter, or when the high flow air filter blockage indicator light warns (regardless of the driving distance), it should be cleaned. Under normal road conditions, the vehicle should drive 7500-8000 km for the cleaning and maintenance of the high flow air filter. In areas with high dust levels, the maintenance interval should be shortened accordingly. Now, let's understand where the high flow air filter is and the installation matters.

　　Generally, the car needs to replace the filter element after driving 15,000 kilometers or about 1 year, and the specific replacement cycle depends on the car's usage and driving environment. If driving frequently in dusty and overcast areas, the replacement cycle should be shortened. Even when it's time to replace it, one may not know how to replace the car's filter element. This is a problem faced by maintenance beginners, and friends may not know where the filter element in the car is. It is obvious at a glance.

　　Where is the high flow air filter?

　　It is located under the engine cover, connected to the engine side with pipes. Some high flow air filters are cylindrical, so they are also called air intake boxes. They are installed in front of the carburetor and intake pipe, serving to remove dust and debris particles from the air, ensuring that the engine receives sufficiently clean and dry air.

　　Installation matters for the high flow air filter:

　　1. During installation, whether the high flow air filter is connected to the engine intake pipe using a flange, rubber hose, or directly, it needs to be tight and reliable to prevent air leakage, and rubber gaskets should be installed on both ends of the filter element; wing nuts should not be tightened too much to avoid crushing the paper filter element.

　　2. During maintenance, manufacturers remind not to wash the paper filter element in oil. Otherwise, the paper filter element will fail, easily causing runaway accidents. During maintenance, only vibration methods, soft brush methods (brush along the wrinkles), or compressed air back-blowing methods can be used to remove dust and dirt attached to the surface of the paper filter element. Dust in the dust collection part, blades, pipes, etc. should be removed immediately. Even with careful maintenance each time, high flow air filter manufacturers cannot fully restore the original performance, and intake resistance will increase. Therefore, generally, when it requires maintenance for the fourth time, a new one needs to be replaced. If there are issues such as cracks, perforations, or delamination of the filter paper and end caps, please replace it immediately.

　　3. When in use, please be careful not to let the high flow air filter get wet by rain. This is because the paper core absorbs a large amount of moisture, which significantly increases intake resistance and shortens the lifespan. Additionally, do not let it come into contact with oil or fire.

　　4. Some vehicle engines are equipped with it. The plastic cover at the end of the filter element is a flow guide, and the blades of the cover cause the air to rotate, separating and collecting 80% of the dust by centrifugal force in the dust collection chamber. The dust reaching the paper filter element is 20% of the inhaled dust amount, with a total filtration efficiency of about 99.7%. Therefore, when maintaining the high flow air filter, please be careful not to leak the plastic guide sleeve on the filter element.

　　The above introduction is about where the high flow air filter is and the installation matters. For more information, feel free to Contact Us! Our company has many years of experience and looks forward to your joining.